Qt4-24 Automatic Concrete Interlocking Brick Block Machine

Qt4-24 Automatic Concrete Interlocking Brick Block Machine

This is still the result after revalidation according to the geotechnical test method,which fully demonstrates that the current geotechnical test method used in the brick and tile industry can’t correctly reflect the characteristics of raw materials such as coal gangue and shale during processing and forming.In order to further prove the fact that raw materials such as shale or coal gangue relys on reducing the particles size to obtain plasticity, the hard shale in a place near Shijiazhuang was crushed into two groups in the laboratory.One group all can pass 0.9 mm sieve; the other can all pass 0.5 mm sieve.However, the shale of the same mineral composition differs greatly in its plasticity index only due to its different grain sizes, one being 4.8% (0.9 mm) and the other being 8.9% (0.5 mm).In order to further verify this phenomenon, this two groups were blended together in different proportions to determine their plasticity index, drying line shrinkage rate and drying sensitivity index. The results are shown in the following table.

Qt4-24 Automatic Concrete Interlocking Brick Block Machine

Different types of augers are available to adapt for varying clay requirements and shaping conditions:

1.Highly wear resistant chromium alloy

2.Steel alloys with chromium or tungsten carbides resurfacing

3.Steel alloy

Qt4-24 Automatic Concrete Interlocking Brick Block Machine

It is ideal product for small clay brick factory who wants to get high quality bricks.

Buyer can choose auto clutch or manual clutch.

JKR28 are mostly sold in South America, such as Peru, Argentina, and African countries such as Tanzania, Mozambique, Cameroon, Rwanda, etc.

Welcome To Our Company Hope We Can Have A Good Cooperation.