Qt5-20ly Used Interlocking Brick Machine For Sale/Block Making Machine Pakistan

Qt5-20ly Used Interlocking Brick Machine For Sale/Block Making Machine Pakistan

 3: Confirm the production process and equipment

Selected production process and equipment according to raw materials.Clarify your raw material properties before starting new plant.Please have experienced technical staff to plan the production route and conduct selection or design production equipment.Not all equipment can adapt to your raw materials.

Qt5-20ly Used Interlocking Brick Machine For Sale/Block Making Machine Pakistan

 5:Preparation before production

1. organization construction

2. Make plans and regulations

3. Maintain and add equipment

4. Clean up the existing dry site and drying supplies

5. Maintain kiln

6. Maintain electrical equipment

7. Prepare sufficient fuel

8. Preparation of auxiliary items for production

9. Construct road and drainage

10. Prepare raw materials in advance

11. Ensure safety precautions

12. Run a test

13. Prepare spare parts

Qt5-20ly Used Interlocking Brick Machine For Sale/Block Making Machine Pakistan

This is still the result after revalidation according to the geotechnical test method,which fully demonstrates that the current geotechnical test method used in the brick and tile industry can’t correctly reflect the characteristics of raw materials such as coal gangue and shale during processing and forming.In order to further prove the fact that raw materials such as shale or coal gangue relys on reducing the particles size to obtain plasticity, the hard shale in a place near Shijiazhuang was crushed into two groups in the laboratory.One group all can pass 0.9 mm sieve; the other can all pass 0.5 mm sieve.However, the shale of the same mineral composition differs greatly in its plasticity index only due to its different grain sizes, one being 4.8% (0.9 mm) and the other being 8.9% (0.5 mm).In order to further verify this phenomenon, this two groups were blended together in different proportions to determine their plasticity index, drying line shrinkage rate and drying sensitivity index. The results are shown in the following table.

Welcome To Our Company Hope We Can Have A Good Cooperation.