Unique Performance Cement Concrete Brick Machine Adjustable Leveling Block Making Machine Price Nepal

Unique Performance Cement Concrete Brick Machine Adjustable Leveling Block Making Machine Price Nepal

Sintered brick process is composed of four parts.To sum up,it is said that the raw material is fundamental,molding is the basis,drying is ensure and roasting is the key. These four parts are interdependent.

Unique Performance Cement Concrete Brick Machine Adjustable Leveling Block Making Machine Price Nepal

This is still the result after revalidation according to the geotechnical test method,which fully demonstrates that the current geotechnical test method used in the brick and tile industry can’t correctly reflect the characteristics of raw materials such as coal gangue and shale during processing and forming.In order to further prove the fact that raw materials such as shale or coal gangue relys on reducing the particles size to obtain plasticity, the hard shale in a place near Shijiazhuang was crushed into two groups in the laboratory.One group all can pass 0.9 mm sieve; the other can all pass 0.5 mm sieve.However, the shale of the same mineral composition differs greatly in its plasticity index only due to its different grain sizes, one being 4.8% (0.9 mm) and the other being 8.9% (0.5 mm).In order to further verify this phenomenon, this two groups were blended together in different proportions to determine their plasticity index, drying line shrinkage rate and drying sensitivity index. The results are shown in the following table.

Unique Performance Cement Concrete Brick Machine Adjustable Leveling Block Making Machine Price Nepal

For example, assuming that the type and total amount of clay minerals contained in a kind of clay are exactly the same as that in a certain type of shale, plasticity index measured by the geotechnical test method is much higher than shale,because  dispersed clay mineral particles in the clay are uniform and small.If the shale is fully crushed, so that the clay minerals in the shale reach a finely dispersed state like the clay mineral particles contained in the clay, it is possible that the plasticity index measured by the geotechnical test method will be the same as that of the clay.However, it can’t be achieved in actual production,causing a great plasticity fluctuation during processing raw materials such as coal gangue and shale.Which method should be used to describe and compare the plasticity of these raw materials?

Welcome To Our Company Hope We Can Have A Good Cooperation.