Qmj4-35a Vibrated Cement Brick Block Making Machine Factory

Qmj4-35a Vibrated Cement Brick Block Making Machine Factory

If the residual moisture rate after drying is less than 6%,the wet billet could be fired in the baking kiln.Hoffman kiln and tunnel kiln are normally used for roasting.When using Hoffman kiln, the brick code is manually placed in the kiln and the fire is roasted in the kiln.When using tunnel kiln,the brick code is manually or mechanically placed in the kiln cart.The kiln car enters kiln head and exits from the kiln tail. The brick blanks on the kiln car are roasted into bricks.The roasting flame in the kiln doesn’t move just the kiln cart.Whether using Hoffman kiln or tunnel kiln,this two conditions must be followed:1.never use underfire to produce unburnt brick.2.never use big fire to produce coke brick.It is often said that roasting is the key of the brick making process,which explains the importance of roasting in the brick making process.

Qmj4-35a Vibrated Cement Brick Block Making Machine Factory

This is still the result after revalidation according to the geotechnical test method,which fully demonstrates that the current geotechnical test method used in the brick and tile industry can’t correctly reflect the characteristics of raw materials such as coal gangue and shale during processing and forming.In order to further prove the fact that raw materials such as shale or coal gangue relys on reducing the particles size to obtain plasticity, the hard shale in a place near Shijiazhuang was crushed into two groups in the laboratory.One group all can pass 0.9 mm sieve; the other can all pass 0.5 mm sieve.However, the shale of the same mineral composition differs greatly in its plasticity index only due to its different grain sizes, one being 4.8% (0.9 mm) and the other being 8.9% (0.5 mm).In order to further verify this phenomenon, this two groups were blended together in different proportions to determine their plasticity index, drying line shrinkage rate and drying sensitivity index. The results are shown in the following table.

Qmj4-35a Vibrated Cement Brick Block Making Machine Factory

2, The body of adobe is not smooth, the obvious particles, more sand pits, and horns or flutes are missing.

Reasons: The shatter of raw materials does not meet the requirements of making bricks because there is much large particles.

Solutions: Install fine grinding equipment, as required for crushing the raw materials to make particles 3 mm or less.

Welcome To Our Company Hope We Can Have A Good Cooperation.