Qt4-15 Semi Automatic Cement Hollow Brick Making Machine In Guatemala Peru Price

Qt4-15 Semi Automatic Cement Hollow Brick Making Machine In Guatemala Peru Price

If the residual moisture rate after drying is less than 6%,the wet billet could be fired in the baking kiln.Hoffman kiln and tunnel kiln are normally used for roasting.When using Hoffman kiln, the brick code is manually placed in the kiln and the fire is roasted in the kiln.When using tunnel kiln,the brick code is manually or mechanically placed in the kiln cart.The kiln car enters kiln head and exits from the kiln tail. The brick blanks on the kiln car are roasted into bricks.The roasting flame in the kiln doesn’t move just the kiln cart.Whether using Hoffman kiln or tunnel kiln,this two conditions must be followed:1.never use underfire to produce unburnt brick.2.never use big fire to produce coke brick.It is often said that roasting is the key of the brick making process,which explains the importance of roasting in the brick making process.

Qt4-15 Semi Automatic Cement Hollow Brick Making Machine In Guatemala Peru Price

The plasticity index of common brick clay is relatively stable.In terms of this type of material, which depends on crushing process reducing particle size to obtain plasticity, its plasticity index is variable during processing.For example, when a certain coal gangue is crushed below 0.9 mm in the laboratory, according to geotechnical test method, the plasticity index is measured as only 7.2%.However, after adding 40% of excessively fired vermiculite (essentially no plasticity),then adding water, aging, and crushing on the roller, vacuum extrusion,plasticity index of the small sample actually reached 10.5%.For example, when other shales were crushed to less 0.9 mm, the plasticity index is measured as 8.4% according to geotechnical test method.However, after adding 40% (by weight) of fly ash,then mixing with water, aging, and crushing,plasticity index of the small sample extruded by the vacuum extruder reached 9.5%.

Qt4-15 Semi Automatic Cement Hollow Brick Making Machine In Guatemala Peru Price

For example, assuming that the type and total amount of clay minerals contained in a kind of clay are exactly the same as that in a certain type of shale, plasticity index measured by the geotechnical test method is much higher than shale,because  dispersed clay mineral particles in the clay are uniform and small.If the shale is fully crushed, so that the clay minerals in the shale reach a finely dispersed state like the clay mineral particles contained in the clay, it is possible that the plasticity index measured by the geotechnical test method will be the same as that of the clay.However, it can’t be achieved in actual production,causing a great plasticity fluctuation during processing raw materials such as coal gangue and shale.Which method should be used to describe and compare the plasticity of these raw materials?

Welcome To Our Company Hope We Can Have A Good Cooperation.