New Condition Qtj4-26c Type Concrete Brick Making Machine Cement Brick Block Maker Machines

New Condition Qtj4-26c Type Concrete Brick Making Machine Cement Brick Block Maker Machines

The natural drying is to place the wet billet on the billet stalk in the natural drying place,manually invert the code and use the atmosphere to wet the cold billet into a dry billet.Artificial drying is to use equipped artificial drying chamber to dry wet billet.The artificial drying room is divided into three types: large-section tunnel drying room, small-section tunnel drying room and chamber drying room.Whichever type is adopted, it is manually or mechanically placing wet billet on a drying truck,then put it into drying chamber.The heat medium in the drying chamber generally comes from the waste heat of the sintering kiln or the hot blast stove.Whichever drying method is adopted, it must be ensured that the blank will not be deformed or chapped during the drying process.If the wet billet can’t guarantee the appearance quality of the product during drying, it will cause high reject rate, falling output,increasing cost of the finished brick, which are definitely harmful to company economic efficiency.This shows the importance of drying wet billet in brick making process.

New Condition Qtj4-26c Type Concrete Brick Making Machine Cement Brick Block Maker Machines

From the above table, it can be clearly seen that the plasticity index, dryness sensitivity index, and dry linear shrinkage of the mixture tend to increase with the increase of the particle composition below 0.5 mm in the mixture.This fully shows that the use of geotechnical test method can not fully evaluate the properties of plastic materials such as shale and coal gangue that rely on reducing particle size.From the above analysis, the plasticity degree has a great relationship with the particle size of clay minerals.

New Condition Qtj4-26c Type Concrete Brick Making Machine Cement Brick Block Maker Machines

2, The body of adobe is not smooth, the obvious particles, more sand pits, and horns or flutes are missing.

Reasons: The shatter of raw materials does not meet the requirements of making bricks because there is much large particles.

Solutions: Install fine grinding equipment, as required for crushing the raw materials to make particles 3 mm or less.

Welcome To Our Company Hope We Can Have A Good Cooperation.