Quality And Quantity Assured Easy Operation Manual Concrete Block Making Machine/Cement Hollow Brick Making Machine

Quality And Quantity Assured Easy Operation Manual Concrete Block Making Machine/Cement Hollow Brick Making Machine

The natural drying is to place the wet billet on the billet stalk in the natural drying place,manually invert the code and use the atmosphere to wet the cold billet into a dry billet.Artificial drying is to use equipped artificial drying chamber to dry wet billet.The artificial drying room is divided into three types: large-section tunnel drying room, small-section tunnel drying room and chamber drying room.Whichever type is adopted, it is manually or mechanically placing wet billet on a drying truck,then put it into drying chamber.The heat medium in the drying chamber generally comes from the waste heat of the sintering kiln or the hot blast stove.Whichever drying method is adopted, it must be ensured that the blank will not be deformed or chapped during the drying process.If the wet billet can’t guarantee the appearance quality of the product during drying, it will cause high reject rate, falling output,increasing cost of the finished brick, which are definitely harmful to company economic efficiency.This shows the importance of drying wet billet in brick making process.

Quality And Quantity Assured Easy Operation Manual Concrete Block Making Machine/Cement Hollow Brick Making Machine

This method has been widely used for many years in the fields of soil science and engineering geology.Although China's brick and tile industry has been using it for many years, it is only for soft and dispersed clay raw materials.For coal gangue, shale, etc., which rely on reducing particle size to obtain plasticity, there is a great deal of deviation in using this method.For example, the plasticity of raw materials such as coal gangue and shale depends on crushing to reduce the particle size to a certain degree, adding water to the particles after decomposing (aging), and it is changeable during processing.If the hard clayey shale or coal gangue rich in illite is ground to a sufficiently fine degree (such as cement fineness),the plasticity index may reach a pretty high level.And formed moisture content and drying shrinkage may be larger than common clay materials, which totally differ from common brick clay.

Quality And Quantity Assured Easy Operation Manual Concrete Block Making Machine/Cement Hollow Brick Making Machine

For example, assuming that the type and total amount of clay minerals contained in a kind of clay are exactly the same as that in a certain type of shale, plasticity index measured by the geotechnical test method is much higher than shale,because  dispersed clay mineral particles in the clay are uniform and small.If the shale is fully crushed, so that the clay minerals in the shale reach a finely dispersed state like the clay mineral particles contained in the clay, it is possible that the plasticity index measured by the geotechnical test method will be the same as that of the clay.However, it can’t be achieved in actual production,causing a great plasticity fluctuation during processing raw materials such as coal gangue and shale.Which method should be used to describe and compare the plasticity of these raw materials?

Welcome To Our Company Hope We Can Have A Good Cooperation.